Installation Guide

INSTALLATION WALKTHROUGH:
For more information log onto www.curtmfg.com, & for helpful towing tips log onto www.hitchinfo.com
7. Insert the 1/2" carriage bolt and spacer into the trunk
pan holes. Apply caulk/sealant to the area between
the trunk pan hole and hitch. Raise hitch into position
and lightly secure with 1/2" hardware.
9. Porsche models: Raise rear fascia up into position and mark
around side plate interference where fascia needs to be
trimmed. Approx. 1/2" by 1" each side. Trim area with
either a cut-off wheel or shears.
After fit is confirmed, clip fascia back into position by following
Steps 1-2 in reverse.
8. In sequence, torque 1/2" hardware to 110 lb-ft, 8mm
bolts to 23 lb-ft, and 3/8" u-bolts to 45 lb-ft. Reinstall lower
bumper fascia by following Steps 1-2 in reverse.
Porsche models: Fascia must be trimmed before reassembly.
Trunk components can be reinstalled at this time
(Step 5 in reverse).
Installation complete