Installation Guide

Parts List
DESCRIPTION
PART NUMBER
QTY
ITEM
BOLT, CAR,1/2-13 UNC,4-1/2,GRD8,YZ
10-10297
4
1
HHCS, M10x1.25,25,CL10.9,YZ
10-10373
4
2
NUT,SER-FLANGE,1/2-13 UNC,GRD8,YZ
20-00062
4
3
WASHER, S-CON,7/16,YZ
30-0016344
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT DISTRIBUTION HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 877-287-8634
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing LLC., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing LLC., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing LLC.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
6,000 900
8,000
900
HYUNDAI SANTA FE (3.3L V6 MODELS)
6/4/2020
13153
30
41
15
HITCH WEIGHT: LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
- NO DRILLING
- LOWER SPARE TIRE
DRIVER SIDE
FRAME RAIL
PASSENGER SIDE
FRAME RAIL
BUMPER LOCATOR PIN
(BOTH SIDES)
EXISTING WELD NUTS
(BOTH SIDES)
3
1
2
4
1. Remove (2) fascia screws and lower center bumper fascia panel.
Note: Panel can be reinstalled after hitch installation is complete.
2. Raise hitch into position and secure to the existing weldnuts with M10-1.25 x 25mm bolts and
7/16" conical toothed washers. Note: You may need to lower spare tire for additional clearance.
3. Insert 1/2-13 x 4 1/2" carriage bolts through the side plates and frame rails, secure using 1/2-13 flange nuts.
Note: You may need to bend or trim the bumper locator pin to allow hardware clearance.
4. Torque all 1/2" hardware to 110 ft-lbs.
Torque all 10mm hardware to 48 ft-lbs.
5. If lowered, raise spare tire back into position. Reinstall the bumper fascia panel removed in Step (1).
TOOLS REQUIRED
RATCHET
TORQUE WRENCH
6" SOCKET EXTENSION
3/4" SOCKET
17mm SOCKET
SCREW DRIVER
SAFETY GLASSES
A
UPDATED HARDWARE DESCRIPTIONS AND PHONE NUMBER, REPLACED 3/8" WASHER WITH 7/16" WASHER
6/4/2020 CJW
REVISION HISTORY
REV DESCRIPTION DATE APPROVED