Installation Guide

Parts List
DESCRIPTIONPART NUMBERQTYITEM
HEX TAP BOLTM12-1.25 x 35mm81
CONICAL TOOTHED WASHER1/2"82
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT DISTRIBUTION HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
HITCH WEIGHT: LBS.
INSTALL TIME: MINUTES
INSTALL NOTES:
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
5,000 500
28
15
6,000
600
13156 / 78141
9/21/2012
NO DRILLING REQUIRED
1) If present remove tow hooks from vehicle frame (Both sides).
2) Raise hitch into position aligning holes in hitch mounting plates with existing weldnuts.
3) Insert fasteners as shown and properly torque all fasteners to 86 lb.-ft.
1
2
EXISTING WELDNUTS
97-04 INFINITI QX4 SUV
96-04 NISSAN PATHFINDER
DRIVER SIDE FRAME RAIL
PASSENGER SIDE FRAME RAIL