Installation Guide

I NSTALLATI ON WALKTHROUGH:
For more information log onto www.curtmfg.com, & for helpful towing tips log onto www.hitchinfo.com
3. Lower exhaust by removing (2) isolators on the driver side
muffler, (2) isolators on the passenger side muffler, and (2)
isolators forward of the mufflers. Note: Exhaust can pivot on
driver side at ball joint location for increased access to rear
vehicle mounting location.
4. Locate plastic fascia support webbing and drill out center
inboard section. Enlarge section for 3/4" socket access in
order to tighten hitch to nut plates over bumper beam.
5. Locate supplied nut plates from hitch and hardware
assembly. Nut plate weldnut threads may need to be
cleaned with a wire brush before assembly.
6. Place supplied nut plates over bumper beam, as shown.
7. Raise hitch into position over exhaust.
8. Secure hitch to nut plates, with finger tightened 1/2" x 5" hex
bolts and 1/2" conical toothed washers, as shown. (Note: Be
sure to slide hitch as far forward as possible but not so it
rests on the weld seam on the vehicle bumper beams.)