Installation Guide

GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY AUXILIARY STABILIZING STRAPS.
** FAILURE TO PROPERLY SUPPORT NON-TRAILER LOADS WILL VOID PRODUCT WARRANTY**
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 1-877-287-8634
HITCH WEIGHT: LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the
product is found to be defective, Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of
purchase. Alteration to, misuse of, or improper installation of this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement
of products found to be defective, and specifically excludes liability for incidental or consequential loss or damage.
3,500 525
33
45
MERCEDES BENZ GLK350
4/15/2014
13177
90
Parts List
DESCRIPTIONPART NUMBERQTYITEM
CONICAL TOOTHED WASHER1/2"121
HEX FLANGE NUT7/16-1422
HEX BOLT1_2 - 13 x 5 HEX 83
CARRIAGE BOLT7/16-14 x 124
HEX BOLT1/2 - 13 x 2 1/245
NUT PLATE WELDMENTCM-NP1W26
NUT PLATE WELDMENT13177-NPW17
- LOWER EXHAUST
- DRILL ACCESS HOLE
2
5
1
3
4
DRIVER SIDE
BUMPER BEAM
PASSENGER SIDE
BUMPER BEAM
MOUNTING STRAP
VEHICLE CROSSMEMBER
PAGE 1 OF 2
POSITION UNDER
CROSS MEMBER
POSITION ABOVE
CROSS MEMBER
6
TOOLS REQUIRED
FLAT HEAD SCREWDRIVER
DRILL, 1/2" DRILL BIT
DIE GRINDER
RATCHET
T40 SHORT TORX BIT
11/16", 3/4" SOCKET
WIRE BRUSH
6" SOCKET EXTENSION
TORQUE WRENCH
7