Installation Guide

Parts List
DESCRIPTIONPART NUMBERQTYITEM
HHCS,M12x1.25,40CL10.9,YZ10-1027721
BOLT,CAR,1/2-13 UNC,2,GRD8,YZ10-1028822
HHCS,1/2-13 UNC,2-1/2,GRD8,YZ10-1040223
NUT, SER-FLANGE,1/2-13 UNC,GRD8,YZ20-0006244
WASHER,FLAT,1/2,YZ
30-0013345
WASHER,LOCK,1/2,YZ
30-0015326
.250 x 1.50 x 2.00" SQUARE HOLE SPACERCM-SP1
27
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH:
LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT DISTRIBUTION HITCH:
LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
HITCH WEIGHT: LBS.
INSTALL TIME: MINUTES
INSTALL NOTES:
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
6,000
600
40
20
10,000
1,000
13180 / 78198 / RRH13180 00-06 TOYOTA TUNDRA PICKUP
08/07/2020
FRAME RAIL
CROSS MEMBER
EXISTING WELDNUT
BUMPER
EXISTING WELDNUT
2
7
5
1
6
4
NO DRILLING REQUIRED
1) Remove two fascia cups on bumper and return to owner.
2) Raise hitch into position.
3) Install 2, 12mm X 40mm fine thread bolts. (hand tighten)
4) Install 2, 1/2" hex bolts with washers into bumper and tighten.
5) Install 2, 1/2" carriage bolts with square hole spacer and hex
flange nut.
6) Torque all fasteners to 110 lb-ft.
3
EXCLUDES TOWABLE BUMPER MODELS