Installation Guide

Parts List
DESCRIPTION
PART NUMBER
QTY
ITEM
NUT, SER-FLANGE,1/2-13 UNC,GRD8,YZ
20-0006261
.250 x 1.38 x 8.94" SQUARE HOLE SPACERCM-SP30
22
BOLT,CAR,1/2-13 UNC,1-3/4,GRD8,YZ
10-1027263
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT DISTRIBUTION HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
HITCH WEIGHT: LBS.
INSTALL TIME: MINUTES
INSTALL NOTES:
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
4,000
400
29
30
6,000
600
13183 / 757231 00-04 NISSAN XTERRA
6/29/2020
NO DRILLING REQUIRED
1
FRAME RAIL
1) Lower spare tire and remove exhaust from rearmost hanger.
2) Place square hole spacer and carriage bolts inside frame as shown.
Note: Square end of spacer must be positioned to the rear of the vehicle.
3) Raise hitch into position and fasten on with 1/2" flange nuts.
4) Torque all fasteners to 110 lb.-ft.
5) Reinstall spare tire.
3
2
1 GENERIC INSTRUCTION SHEET 8/24/2007 DWS
2 REMOVED SP25 FROM PARTS LIST 11/9/2007 DWS
3
REMOVED STEP 5 FROM INSTALLATION STEPS (PLACE SPACER BETWEEN EXHAST HANGER AND BRACKET)
3/4/2009
JWT
4
CHG TO GRADE 8 TORQUE SPECS
7/16/2012
AJP
REVISION HISTORY
REV DESCRIPTION DATE APPROVED