Installation Guide

Parts List
DESCRIPTION
PART NUMBER
QTY
ITEM
NUT, SER-FLANGE,1/2-13 UNC,GRD8,YZ20-0006241
WASHER,LOCK,9/16,YZ30-0019442
HHCS,1/2-13 UNC,1-3/4,GRD8,YZ10-1037043
.250 x 1.50 x 1.50" ROUND HOLE SPACERCM-SP222
4
.250 x 1.50 x 2.00" ROUND HOLE SPACERCM-SP16
45
WASHER,FLAT,9/16,YZ
30-0020026
HHCS,M14x2,40,CL10.9,YZ
10-1040447
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT DISTRIBUTION HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
HITCH WEIGHT: LBS.
INSTALL TIME:
MINUTES
INSTALL NOTES:
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
8,000
800
52
40
12,000
1,200
13208 CHEVY/GMC 2500 & 3500 PICKUPS
5/21/2020
5
1
4
2
7
6
2
7
DRIVER SIDE
FRAME RAIL
PASSENGER SIDE
FRAME RAIL
MOUNT TO BUMPER
(WELDNUTS IN BUMPER)
EXISTING WELDNUTS
(BOTH SIDES)
1) Remove existing 14mm fasteners from end of each frame rail if present and return to customer.
2) Trim bumper fascia for access to weldnuts in bumper and clearance for bumper mount.
3) Lift receiver into position, locating slots in hitch over weldnuts in vehicle frame.
4) Install 14mm fasteners through hitch into weldnuts in vehicle frame and bumper.
5) On 6' short box, use hitch as a template to drill for center attachment on both sides as shown above.
6) Torque all 14mm fasteners to 126 lb-ft, and all 1/2" fasteners to 110 lb-ft.
- DRILLING REQUIRED (6' BOX ONLY)
- TRIMMING REQUIRED
- LOWER SPARE TIRE FOR EASE OF
INSTALLATION
DRILL HOLE IN FRAME FOR
6' BOX ONLY (BOTH SIDES)
3