Installation Guide

Parts List
DESCRIPTIONPART NUMBERQTYITEM
FISHWIRE TOOL1/2"
11
WASHER5/862
5/8-11 HEX BOLT5/8-11 x 1 1/2 HEX BOLT33
CONICAL TOOTHED WASHER1/2"24
HEX BOLTM12-1.25 x 35mm25
HEX FLANGE NUTHFN 121316
.250 x 1.50 x 2.00" SQUARE HOLE SPACERCM-SP1
17
CARRIAGE BOLT1/2-13 x 1 3/418
HEX FLANGE NUT5/8-1139
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT DISTRIBUTION HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
HITCH WEIGHT: LBS.
INSTALL TIME: MINUTES
INSTALL NOTES:
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
4000 400
30
30
6000
600
13222 / 78172
7/17/2012
1) Position hitch on the vehicle as shown, align holes in hitch with existing weldnuts in vehicle frame
(passenger side) and slots in tow hook mounting pad (driver side). Loosely install hex bolts as shown.
2) Fishwire carriage bolt and spacer through end of frame on passenger side and install as shown.
3) Tighten fasteners on the driver side and fastener on side of frame on passenger side first. Tighten fasteners
on bottom of frame on passenger side last.
4) Use (2) 5/8" flat washers for spacing between the hitch and tow hook mounting pad on the driver side.
5) Torque M12 fasteners to 86 lb-ft, 1/2" fasteners to 110 lb-ft, and 5/8" fasteners to 210 lb-ft.
5
4
6
8
7
FRAME RAIL
EXISTING
WELDNUTS
EXISTING HOLE
1
- NO DRILLING REQ.
- FISHWIRE FASTENER
- LOWER SPARE FOR EASE
OF INSTALLATION
WILL NOT FIT 3.5L
98-04 ISUZU RODEO, 02-03 ISUZU AXIOM &
98-02 HONDA PASSPORT
9
3
2
TOW HOOK MOUNTING PAD