Installation Guide

INSTALLATION WALKTHROUGH:
For more information log onto www.curtmfg.com, & for helpful towing tips log onto www.hitchinfo.com
3. Locate on heat shield and remove (6) nuts using 8mm
socket, (2) screws using E-10 socket, and (2) screws using
10mm socket. Remove heat shield and set aside for
reinstallation.
4. Remove trunk liner guard using T-30 socket to remove
screw. Gently unclip trunk liner guard and remove trunk
contents to expose bumper beam nut inside vehicle. Set
aside trunk contents and trunk liner guard for reinstallation.
5. Inside trunk locate and remove bumper beam nuts, (2) on
each side, using 16mm socket.
NOTE: Removing trunk liner bin on driver side may ease
installation.
6. Under vehicle locate and remove bumper beam nuts, (2) on
each side, using 16mm socket.