Installation Manual

GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT DISTRIBUTION HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT
WARNING: *** DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY. ***
FOR MORE INFORMATION LOG ONTO WWW.CURTMFG.COM & FOR HELPFUL TOWING TIPS LOG ONTO WWW.HITCHINFO.COM
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 1-800-798-0813
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
CURT Manufacturing LLC., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser.
If the product is found to be defective, CURT Manufacturing LLC., may repair or replace the product, at their option, when the product is returned, prepaid,
with proof of purchase. Alteration to, misuse of, or improper installation of this product voids the warranty. CURT Manufacturing LLC.'s liability is limited to
repair or replacement of products found to be defective, and specifically excludes liability for incidental or consequential loss or damage.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C.Regulation V-5 and SAE J684.
8,000 800
12,000 1,200
NISSAN TITAN
1/10/2017
13304
30
48
15
HITCH WEIGHT:
LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
Scan
for more
information
Parts List
DESCRIPTIONPART NUMBERQTYITEM
CONICAL TOOTHED WASHER1/2"
101
HEX BOLT
M12 - 1.25 x 40 HEX102
EXISTING WELDNUTS (ALL)
2
1
1. If present on vehicle remove tow hooks before installing hitch. Return hooks and
and hardware to vehicle owner.
2. Raise hitch into position. Fasten hitch by threading (10) M12 x 40mm bolts with conical
washers into existing weld nuts, as shown above.
3. Torque 12mm fasteners to 86 lb-ft.
- NO DRILLING REQUIRED
- REMOVE TOW HOOK
TOOLS REQUIRED
17mm & 19mm SOCKETS
RATCHET
TORQUE WRENCH
SAFETY GLASSES
DRIVER SIDE
FRAME RAIL
PASSENGER SIDE
FRAME RAIL