Installation Manual

INSTALLATION WALKTHROUGH:
For more information log onto www.curtmfg.com, & for helpful towing tips log onto www.hitchinfo.com
3. Remove plastic insert (if present) &/or electrical harness clip
between hitch mounting locations on passenger side frame
rail. Unfasten electrical harness clip on outside of the driver
side frame rail & follow harness to unfasten nearest clip
towards center of vehicle.
4. Lower exhaust by removing two to four (depending on
vehicle) rearmost rubber hangers. Leave rubber hangers
attached to the vehicle.
5. To ease installation tape four 1/2" flat washers into position
on the inside of hitch side plates.
6. Fishwire 1/2" carriage bolt with CM-SP12 spacer in through
access hole and out rearmost mounting location in the passenger
frame rail. Repeat on rearmost mounting location in driver side
frame rail (if there is no weldnut in frame). Leave hardware fully
inside of frame rail(s) with fishwire(s) attached. See FISHWIRE
TECHNIQUE diagram on page 2.



