Installation Guide

GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH:
LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT DISTRIBUTION HITCH:
LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
HITCH WEIGHT: LBS.
INSTALL TIME: MINUTES
INSTALL NOTES:
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
5,000
500
48
30
7,500
750
13358
07/06/2020
Parts List
DESCRIPTIONPART NUMBERQTYITEM
HHCS,M12x1.75,120,CL10.9,YZ10-1028321
NUT,FLANGE,M12x1.75,CL10,YZ
20-0017622
.375 x 1.25 x 2.00" ROUND HOLE SPACERCM-SP56
23
SIDE VIEW OF PROPERLY
INSTALLED HITCH
1
3
2
EXISTIING HEX BOLTS
(REVERSE AND INSTALL
AS SHOWN)
BUMPER MOUNTING BRACKET
(TYPICAL BOTH SIDES)
EXISTING FLANGE NUTS
(TYPICAL BOTH SIDES)
1) Remove all existing nuts from bumper mounting bracket bolts.(3 per side) Note: Only remove nuts at this
time. Removal of all bolts and nuts at the same time will cause the step bumper to fall and possibly cause
step bumper and personal injury.
2) One at a time, remove bolt and reverse placement, inserting bolt from inside of frame outward. Push bolt
into bumper mounting bracket hole and three-quarters of the way through frame. Repeat this for all existing
bolts.
3) Place hardware provided into existing holes as shown.
4) Raise hitch into position aligning holes as shown. Push the remainder of each bolt through holes and
fasten using nuts.
5) Torque all M12 fasteners to 79 lb-ft.
STEP BUMPER
PASSENGER SIDE FRAME RAIL
DRIVER SIDE FRAME RAIL
TOOLS REQUIRED
3/8" RATCHET
18MM DEEP WELL SOCKET
18MM BOX END WRENCH
- NO DRILLING REQUIRED
SPRINTER 2500 & 3500 VAN (ALL) W/ FACTORY
STEP BUMPER 144" & 170" WHEEL BASE (EXCEPT 3500 144")