Installation Guide

INSTALLATION WALKTHROUGH:
For more information log onto www.curtmfg.com
Vehicles with Dual Exhaust System (skip to step 3 for Single Exhaust)
1. Using a 15mm socket, remove the exhaust hanger bracket on the driver
side. Remove the passenger side exhaust hanger bracket hardware but
leave the bracket on the exhaust hanger.
2. Using a 10mm socket, locate and remove the (3) hex bolts securing the
driver side exhaust bezel. Save for reinstallation.
3. Remove the (2) existing hex bolts from the frame on both sides of the
vehicle.
PASSENGER SIDE
FRAME RAIL
DRIVER SIDE
FRAME RAIL
SPRING
SHACKLE
SPRING
SHACKLE
EXISTING
M14 BOLTS
(BOTH FRAMES)
Note: Some models may require adjustment to the factory
safety chain loops to provide clearance for the hitch pin.
Using an adjustable wrench, bend the loops upward as
needed. (see photo above)