Installation Guide

GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
HITCH WEIGHT: LBS.
INSTALL TIME: MINUTES
INSTALL NOTES:
- NO DRILLING REQUIRED
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
13429 99-03 LEXUS RX 300, 01-03 TOYOTA HIGHLANDER
3,500
350
34
30
6/30/2020
Parts List
DESCRIPTION
PART NUMBER
QTY
ITEM
HEX TAP BOLT10-1029861
WASHER,S-CON,3/8,YZ30-0014862
1) Under the rear of the vehicle, locate and remove the tie down brackets on both left and right frame rails.
Return these to the customer. Remove the plastic caps in the forward threaded holes.
2) Raise the hitch into position under vehicle frames and over the exhaust.
3) Attach at three (3) 10mm threaded holes in each frame rail using the fasteners provided as shown.
4) Torque all M10 hardware to 48 lb.-ft.
DRIVER SIDE
FRAME RAIL
PASSENGER SIDE
FRAME RAIL
EXISTING WELD NUTS
2
1
EXISTING WELD NUTS