Installation Guide

INSTALLATION WALKTHROUGH:
For more information log onto www.curtmfg.com
3. Fishwire 7/16" carriage bolts and spacers through the access
holes in both sides of the frame into the three mounting holes.
Trim and reinstall the heat shield using the (2) outer-most
fasteners, the heat shield will be sandwiched between the
sideplate and the frame.
4. Remove (2) push pins from the rear fascia, bend push pin
mounting tabs away from the rear of the vehicle to allow
space to raise hitch into place. Mark and trim the rear fascia,
using the trim diagram as a reference.
5. Raise hitch into place and secure hitch to frame using the
7/16" hardware provided. Torque all hardware to 70 lb-ft.
Raise exhaust back into place and reattach exhaust hangers.
3.25"
2.50"