Installation Guide
Parts List
DESCRIPTIONPART NUMBERQTYITEM
1/2" FISHWIRE1_2 FISHWIRE11
HHCS,M12x1.75,40,CL10.9,YZ10-1038632
WASHER,S-CON,1/2,YZ
30-0014933
NUT, SER-FLANGE,1/2-13 UNC,GRD8,YZ
20-0006234
.188 x 1.00 x 3.00" SQUARE HOLE SPACERCM-SP40
35
BOLT,CAR,1/2-13 UNC,1-3/4,GRD8,YZ
10-1027236
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY AUXILIARY STABILIZING STRAPS.
** FAILURE TO PROPERLY SUPPORT NON-TRAILER LOADS WILL VOID PRODUCT WARRANTY**
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 1-877-287-8634
HITCH WEIGHT: LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
3500 350
31
30
7/30/2020
13465
60
75171
1) Lower exhaust by removing the (2) hangers and (1) rubber mount on the 300 limited.
(Note the 300C and Dodge Magnum will have (4) hangers and (2) rubber mounts for dual exhaust.)
2) Fishwire 1/2" carriage bolts and spacer blocks through existing holes in the frame as shown.
3) Slide hitch over muffler(s) and into position over the 1/2" carriage bolts.Secure with flange nuts, finger tight only.
4) Install 12mm hex bolts and conical washers in remaining holes,finger tight only.
5) Torque all 1/2" fasteners to 110 lb-ft, torque all 12mm fasteners to 79 lb-ft.
6) Reinstall exhaust hangers removed in step (1).
-NO DRILLING REQUIRED
-FISHWIRE FASTENERS
6
5
4
2
3
CHRYSLER 300 LIMITED, 300C, MAGNUM RT/SXT/SE
CHARGER R/T AND CHALLENGER