Installation Guide

ManualsBrandsCURT ManualsOtherClass 3 Trailer Hitch, 2" Receiver, Select Nissan Quest, Towing Draw Bar

Parts List

DESCRIPTIONPART NUMBERQTYITEM

WASHER,S-CON,1/2,YZ30-0014961

HEX TAP BOLT10-1027762

GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.

GROSS LOAD CAPACITY WHEN USED AS A WEIGHT DISTRIBUTION HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT

***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***

HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 1-877-287-8634

INSTALLATION STEPS

PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS

ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.

Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,

Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of

this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or

consequential loss or damage.

3,500 300

5,000

500

NISSAN QUEST

7/15/2020

13563

HITCH WEIGHT:

LBS.

INSTALL TIME

PROFESSIONAL: MINUTES

NOVICE (DIY): MINUTES

INSTALL NOTES:

75884

1. Remove the plastic rivets that fasten the bumper fascia tabs to the back of vehicle. (Note: To do this,

remove the center of the rivet with a screwdriver, or from the top side, push down on the center

piece in rivet and remove. Keep these rivets and put them back in after hitch is installed.)

2. Lower the exhaust by removing the rubber from the muffler hanger and by loosening the two nuts that

secure the exhaust hanger bracket to the chassis, ahead of the muffler adjacent to rear axle.

3. Pull and hold muffler to the side to remove the screw attaching the ground strap to the passenger side

frame rail. Keep this screw.Remove the two screws that attach the aluminum heat shield to the frame.

Return heat shield and screws to customer.

4. Raise hitch into place and loosely install the 12mm hex bolts and conical toothed washers.

(Note: Position hitch toward driver side to allow maximum muffler clearance.)

5. Torque all 12mm fasteners to 86 lb.-ft.

6. Reinstall ground strap and screw. Lift exhaust back into postion and re-install hangers.

-LOWER EXHAUST

-NO DRILLING REQ

EXISTING WELDNUTS

IN FRAME