Installation Guide

Parts List
DESCRIPTION
PART NUMBER
QTY
ITEM
.250 x 1.50 x 2.00" SQUARE HOLE SPACERCM-SP141
NUT, SER-FLANGE,1/2-13 UNC,GRD8,YZ20-0006242
BOLT,CAR,1/2-13 UNC,1-3/4,GRD8,YZ10-1027243
HHCS,M14x2,40,CL10.9,YZ10-10404
44
WASHER,S-CON,9/16,YZ
30-0016425
WASHER,LOCK,9/16,YZ
30-0019426
WASHER,FLAT,9/16,YZ
30-0020027
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT DISTRIBUTION HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
HITCH WEIGHT: LBS.
INSTALL TIME:
MINUTES
INSTALL NOTES:
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
10,000
1,000
50.5
45
12,000
1,200
14108 01-07 CHEVY/ GMC HD PICKUPS 6' BED
8/5/2020
EXISTING WELDNUTS
1
6
2
1) Remove the 14mm hex bolt from each end of the frame.
2) Remove and relocate the ground wire and ground bolt on the driver's side frame rail.
3) Raise the hitch into position and install the fasteners as shown.
4) Torque 1/2" fasteners to 110 lb-ft.
Torque 14mm fasteners to 126 lb-ft.
NO DRILLING REQUIRED
3
4
5
7