Owners manual

GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT DISTRIBUTION HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT
WARNING: *** DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY. ***
FOR MORE INFORMATION LOG ONTO WWW.CURTMFG.COM & FOR HELPFUL TOWING TIPS LOG ONTO WWW.HITCHINFO.COM
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 1-800-798-0813
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
CURT Manufacturing LLC., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser.
If the product is found to be defective, CURT Manufacturing LLC., may repair or replace the product, at their option, when the product is returned, prepaid,
with proof of purchase. Alteration to, misuse of, or improper installation of this product voids the warranty. CURT Manufacturing LLC.'s liability is limited to
repair or replacement of products found to be defective, and specifically excludes liability for incidental or consequential loss or damage.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C.Regulation V-5 and SAE J684.
16,000 2,400
17,000 2,400
NISSAN TITAN XD
5/13/2016
15306
60
55
30
HITCH WEIGHT:
LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
Scan
for more
information
1. Remove (10) M12 bolts from the vehicle using a 17mm socket as shown above. Loosening the (2) remaining
bumper/hitch bolts and (4) spring shackle reinforcement bracket bolts will aid bolt removal.
NOTE:
Be sure not to strip the threads of any of the bolts removed or loosened.
2. Raise hitch into position and reinstall bolts removed in step 1.
3. Torque all M12 fasteners to 86 lb-ft.
EXISTING VEHICLE FASTENERS
PASSENGER SIDE
FRAME RAIL
FACTORY HITCH
DRIVER SIDE
FRAME RAIL
- NO DRILLING REQUIRED
- FITS BELOW FACTORY HITCH
TOOLS REQUIRED
RATCHET
TORQUE WRENCH
17mm SOCKET