Installation Guide

GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT DISTRIBUTION HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT
1-877-287-8634
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing LLC., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing LLC., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing LLC.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
16,000 2,400
17,000 2,400
07/13/2020
15324
60
51
30
HITCH WEIGHT: LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
Parts List
DESCRIPTIONPART NUMBERQTYITEM
BOLT,CAR,1/2-13 UNC,1-3/4,GRD8,YZ
10-1027241
NUT, SER-FLANGE,1/2-13 UNC,GRD8,YZ20-0006242
.250 x 1.00 x 2.50" SQUARE HOLE SPACERCM-SP10
4
3
1/2" FISHWIRE1_2 FISHWIRE
24
1. To ease hitch installation, lower the spare tire.
2. Remove the two bolts (one each side) from the bumper bracket on the bottom of the frame. (NOTE: Do not
discard the bolts as they are reinstalled in Step 3.)
3. Raise the hitch into position and reinstall the bolts removed in Step 2.
4. Install 1/2"-13 x 1 3/4" carriage bolts and CM-SP10 spacers through the access windows on the inside of
each frame rail into each of the remaining (4) mounting holes in the frame rails and hitch.
5. Secure the hitch with the 1/2" hex flange nuts, as shown.
6. Torque all 1/2" hardware to 110 ft-lbs. Torque all 14mm hardware to 126 ft-lbs.
7. Replace spare tire lowered in Step 1.
EXISTING WELD NUT
(BOTH SIDES)
EXISTING BOLT
(BOTH SIDES)
PASSENGER SIDE
FRAME RAIL
DRIVER SIDE
FRAME RAIL
1
3
4
TOOLS REQUIRED
3/4" SOCKET
21mm SOCKET
12" EXTENSION
RATCHET
TORQUE WRENCH
2003-2006 CHEVY TAHOE / SUBURBAN AND GMC YUKON / DENALI;
2003-2006 CADILLAC ESCALADE; 2003-2006 CHEVY AVALANCHE
- NO DRILLING REQUIRED
- FISHWIRE HARDWARE
- LOWER SPARE TIRE
2