Installation Guide
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT DISTRIBUTION HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 1-877-287-8634
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing LLC., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing LLC., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing LLC.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
20,000 2,700
20,000 2,700
FORD F-250 / F-350 / F-450 SUPER DUTY
6/17/2020
15810
60
76
30
HITCH WEIGHT:
LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
Parts List
DESCRIPTION
PART NUMBER
QTY
ITEM
BOLT,CAR,9/16-12 UNC,1-3/4,GRD8,YZ10-1032881
NUT,SER-FLANGE,9/16-12 UNC,GRD8,YZ20-0010482
.313 x 1.25 x 2.00" 9/16" SQUARE HOLE SPACERCM-SP7383
Note: To ease installation, temporary removal of the spare tire is recommended.
1. Position the hitch against the frame, aligning the holes in the hitch with the holes in the frame.
Take note of the fastener locations and lower the hitch.
2. Place a carriage bolt and spacer into each bolt location from inside the frame rail as shown.
3. Raise the hitch into position and secure it to the frame rails using hex flange nuts.
4. Torque all hardware to 150 lb-ft.
TOOLS REQUIRED
13/16" WRENCH
7/8" SOCKET
12" EXTENSION
SOCKET WRENCH
TORQUE WRENCH
DRIVER SIDE
FRAME RAIL
PASSENGER SIDE
FRAME RAIL
DRIVER SIDE
PLATE
PASSENGER
SIDE PLATE
- NO DRILLING REQUIRED
3
1
2
DOES NOT FIT WITH 20" SPARE TIRE