Installation Guide

ManualsBrandsCURT ManualsOtherOEM Puck System 5th Wheel Roller for Ford

Read and understand instructions before using this product.

Fully instruct and demonstrate the operation of this 5th

wheel hitch to the end user. Include the importance of

observing all warnings contained herein, including warning

labels on 5th wheel hitch mid section. Provide this manual in

its entirety to the end-user.

To avoid serious injury, do not expose hands, body parts

or clothing between the truck and trailer or the truck's bed

sides and trailer. Extreme care should be observed to avoid

serious injury to self, property and observers.

Never position yourself or others under the trailer's kingpin

area during coupling and uncoupling. Serious injury or

death may result if the warning above is not observed.

This product complies with V-5 regulations and safety

requirements for connecting devices and towing systems of

the State of Wisconsin.

WARNINGS

WARNING: NEVER EXCEED YOUR VEHICLE MANUFACTURER S RECOMMENDED TOWING CAPACITY

INSTALLATION INSTRUCTIONS

FORD OEM COMPATIBLE 5TH WHEEL ROLLER

PARTS LIST

UNPACKING THE ROLLER

Inspect all parts for damage and verify

that all items listed are present.

Figure 1

Item# Qty Description

1 1 Roller assembly, driver side (DS)

2 1 Roller assembly, passenger side (PS)

3 1 Handle assembly

4 1 Handle center section

5 1 Cross member weldment

6 2 End connector

7 1 Compression spring

8 4 Flat head socket cap screw, M10 x 25mm

9 8 Hex head cap screw, M14 x 25mm

PAGE 1 • 16020-INS-RA • 1.800.798.0813 • NEED ASSISTANCE? • CURTMFG.COM

Summary of content (4 pages)

PAGE 1
INSTALLATION INSTRUCTIONS WARNING: NEVER EXCEED YOUR VEHICLE MANUFACTURER S RECOMMENDED TOWING CAPACITY FORD OEM COMPATIBLE 5TH WHEEL ROLLER UNPACKING THE ROLLER WARNINGS Inspect all parts for damage and verify that all items listed are present. Read and understand instructions before using this product. Fully instruct and demonstrate the operation of this 5th wheel hitch to the end user.
PAGE 2
ASSEMBLY INSTRUCTIONS Step 1 Grease the ends of the handle assembly (#3) and the handle center section (#4) as shown in figure 2. 8 5 2 1 4 Grease 3 4 Figure 2 Step 2 Slide the handle assembly (#3) into the driver side roller assembly (#1) and slide the handle center section (#4) into the passenger side roller assembly (#2) as shown in figure 3. Step 3 Slide the compression spring (#7) over the handle assembly (#3) as shown in figure 3.
PAGE 3
5TH WHEEL HEAD INSTALLATION T-BOLT ADJUSTMENT Install the 16515, 16520, 16530 or the 16545 5th wheel head by sliding it into the roller assembly as shown in figure 7. Select desired height using the adjustment holes in the mid section of the 5th wheel head. From the inside, secure the head unit to the roller assembly with the four 14mm bolts supplied. Torque to 100 foot-lbs. Step 1 The locking T-bolts have been pre-installed to ease installation.
PAGE 4
OPERATING INSTRUCTIONS WARRANTY To maneuver Ten year limited Align trailer and tow vehicle in a straight line, on a level surface. CURT Manufacturing, LLC (CURT) warrants to the original purchaser (Purchaser), its products to be free from defect under normal use and service, ordinary wear and tear excepted, for the warranty period stated below, from the date of the original retail purchase, but subject to the limitations as set forth below.