Owners manual

WARNINGS

PARTS LIST

CLAMP-ON BIKE RACK

WARNING: NEVER EXCEED YOUR VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY

INSTALLATION INSTRUCTIONS

2 3

Check straps for wear, and replace if worn.

This product is not intended for off-road use,

tandems or recumbents.

Do not install on a trailer or other towed vehicle.

Check tightness of all bolts and knobs periodically.

Item# Qty Description

1 1 Bike rack

2 1 Collapsing knob

3 6 Arm strap, rubber

PAGE 1 • 18013-INS-RA • 1.800.798.0813 • NEED ASSISTANCE? • CURTMFG.COM

PAGE 1
INSTALLATION INSTRUCTIONS WARNING: NEVER EXCEED YOUR VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY CLAMP-ON BIKE RACK WARNINGS Check straps for wear, and replace if worn. This product is not intended for off-road use, tandems or recumbents. Do not install on a trailer or other towed vehicle. Check tightness of all bolts and knobs periodically. 1 PARTS LIST Item# Qty Description 1 1 Bike rack 2 1 Collapsing knob 3 6 Arm strap, rubber 2 PAGE 1 • 18013-INS-RA • 1.800.798.
PAGE 2
ASSEMBLY & INSTALLATION Step 1 Insert the collapsing knob (#2) in the corresponding hole on the bike rack and turn clockwise to unlock the bike rack arm posts. Leave in until ready to store again. See figure 1. Raise the arm posts to the upright position. See figure 2. Step 4 Loosen the collapsing knob (#2). Using the release handle, push down to spread the bike rack arms into the traveling position. Lock the collapsing knob (#2) into place.