Installation Guide

Parts List
DESCRIPTIONPART NUMBERQTYITEM
HEX BOLTM12 - 1.25 x 40 HEX41
.375 x 1.25 x 2.50" SQUARE HOLE SPACERCM-SP4322
CONICAL TOOTHED WASHER1/2"43
HEX BOLT1_2 - 13 x 424
FW, 12, ZPFW1225
HEX FLANGE NUTHFN 121326
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
GROSS LOAD CAPACITY WHEN USED AS A STRAIGHT LINE PULL: 9,000 LBS. MAX. LINE PULL.

HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT
1-877-287-8634
INSTALLATION STEPS


Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
5,000 500
TOYOTA TACOMA
10/19/2012
31013
90
33
45
HITCH WEIGHT: LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
EXISTING WELD NUTS
EXISTING WELD NUTS
DRILLING REQUIRED
1. Remove tow hooks from vehicle if present and return to customer.
2. Enlarge (2) existing holes in frame rails using a 9/16" drill, as shown.
3. Raise hitch into position and secure with (4) M12 bolts and conical washers, finger tight.
4. Slide CM-SP43 spacers between frame and hitch side plate. Install 1/2" bolts and flat
washers and secure with flange nuts as shown.
5. Torque all M12 fasteners to 86 lb-ft and all 1/2" fasteners to 110 lb-ft.
FRAME RAIL
4
5
6
ENLARGED HOLE
ENLARGED HOLE
FRAME RAIL
3
1
2