Installation Guide

GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
GROSS LOAD CAPACITY WHEN USED AS A STRAIGHT LINE PULL: 9,000 LBS. MAX. LINE PULL.
*** DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY. ***
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 1-877-287-8634
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing LLC., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing LLC., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing LLC.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
5,000 500
TOYOTA LAND CRUISER, TUNDRA, AND SEQUOIA
7/9/2020
31198
45
26
20
HITCH WEIGHT:
LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
PASSENGER SIDE
FRAME RAIL
DRIVER SIDE
FRAME RAIL
TOW HOOK
(BOTH SIDES)
EXISTING HARDWARE
(BOTH SIDES)
EXISTING FRAME
WELDNUTS
- NO DRILLING REQUIRED
- REMOVE TOW HOOKS
- RE-INSTALL TOW HOOKS
- MAY REQUIRE SKID SHIELD TRIMMING
1) Remove tow hooks from vehicle.
NOTE:
If present, Remove the front skid shield and enlarge the hole shown in the diagram above to allow
for oil filter changing. Reinstall trimmed skid shield.
NOTE:
For 2017 Land Cruiser models, trimming the skid shield may be required to ease installation.
Refer to Front Skid Shield Trim Diagram
2) Raise hitch into position, Re-install tow hooks with original fasteners.
NOTE:
For 2017 models, return tow hooks to owner.
3) Torque all 12mm fasteners to 79 lb-ft.
TOOLS REQUIRED
17mm SOCKET
6" EXTENSION
RATCHET
DRIVER SIDE PASSENGER SIDE
FRONT SKID SHEILD TRIM DIAGRAM
4" HOLE