Installation Guide

GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
GROSS LOAD CAPACITY WHEN USED AS STRAIGHT LINE PULL: LBS. MAX. LINE PULL.
DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
HITCH WEIGHT: LBS.
INSTALL TIME:
MINUTES
INSTALL NOTES:
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
5000
500
32
20
9000
31221 CHEVROLET COLORADO / GMC CANYON
EXCLUDING Z71 MODELS WITH FRONT STABILIZER BAR
Parts List
DESCRIPTION
PART NUMBER
QTY
ITEM
FISHWIRE TOOL1/2"11
CARRIAGE BOLT1/2-13 x 1 3/422
.250 x 1.25 x 2.00" SQUARE HOLE SPACERCM-SP323
HEX FLANGE NUTHFN 121324
HEX BOLT3/4-10 x 4.002
5
HEX FLANGE NUT
3_4 - 10 HFN26
-NO DRILLING REQUIRED
-LOWER FASCIA TRIMMING
REQUIRED ON 2010 MODELS
1) Mark and trim lower fascia, or remove lower fascia and return to owner.
(See Fascia Trim Detail) (2010 models only)
2) Fishwire 1/2" carriage bolts and spacers through existing hole in side of frame rail
and out existing hole in bottom of frame rail.
3) Lift hitch into position over 1/2" bolts and secure with flange nuts.
4) Install 3/4" bolts through hitch and frame and secure with flange nuts.
5) Torque all 1/2" fasteners to 110 lb-ft and all 3/4" fasteners to 227 lb-ft.
1
2
3
6
5
4
PASSENGER SIDE FRAME RAIL
DRIVERS SIDE FRAME RAIL
EXISTING HOLES
11/5/2018
FASCIA TRIM DETAIL
BUMPER COVER
NOTE: DIMENSIONS ARE APPROXIMATE
CONFIRM FIT PRIOR TO TRIMMING
LOWER FASCIA
3.00 in
.50 in
LOWER FASCIA