Installation Guide

Parts List
DESCRIPTION
PART NUMBER
QTY
ITEM
BOLT,CAR,1/2-13 UNC,2,GRD8,YZ10-1028861
NUT, SER-FLANGE,1/2-13 UNC,GRD8,YZ20-0006262
.250 x 1.50 x 3.00" SQUARE HOLE SPACERCM-SP463
1/2" FISHWIRE1_2 FISHWIRE64
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
GROSS LOAD CAPACITY WHEN USED AS A STRAIGHT LINE PULL: 9,000 LBS. MAX. LINE PULL.
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
HITCH WEIGHT: LBS.
INSTALL TIME: MINUTES
INSTALL NOTES:
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
5,000
500
35
30
FORD F-150 AND LINCOLN MARK LT
2003-2006 FORD EXPEDITION
08/11/2020
*** LOWER FASCIA TRIMMING MAY BE REQUIRED ON SOME MODELS***
31352
1) Temporarily remove tow hooks for hitch installation.
2) Raise hitch into position. Loosely fasten hitch with existing fasteners at center hole location, each side.
3) Reinstall tow hook by passing bolt head through slot in tow hook. Align hitch and tow hooks with forward
most hole and install the previously removed fasteners.
4) Fishwire remaining fasteners to rearmost mounting holes through access holes on side of frame.
5) Torque fasteners as follows: 12mm fasteners to 79 lb.-ft. & 1/2" fasteners to 110 lb.-ft.
FRAME RAIL
ACCESS SLOT
TOW HOOK
EXISTING NUT STRIP
SLOT IN TOW HOOK
EXISTING FASTENERS
(BOTH SIDES)
- REMOVE TOW LOOPS
- RE-INSTALL TOW LOOPS
- FASCIA TRIMMING REQUIRED
1
3
2
EXISTING TOW HOOKS ON FORD F-150, USE SUPPLIED
FASTENERS FOR INSTALLATION ON LINCOLN MARK LT.
4