Installation Guide

If copying/pasting, eye-drop this text to
ensure a uniform look for all installation
paragraphs.
1. Open the trunk and remove the vehicles rear scuff
panel. On the passenger side remove the battery
compartment cover to reveal the vehicles wiring
harness. Repeat on the drivers side removing the felt
trunk liner.
2. On the passengers side seperate the vehicles
taillight harness by using a flathead screwdriver to
depress the locking tab. Place full assembly in
battery compartment. Insert the T-Connector end with
the green wire in-between the separated housings
making sure the locking tabs are in place.
3. Route the T-Connector end with the yellow wire
under the felt trunk liner and under the vehicles
removed rear scuff panel, under the felt trunk liner on
the drivers side. Repeat step 2 on the drivers side using
the T-Connector end with the yellow wire.
4. On the passengers side disconnect the vehicles
positive battery cable. Attach the the terminal ring to
the vehicles positive battery post and reconnect the
positve battery cable. Insert the fuse provided into the
fuse holder.
5. Locate a suitable grounding point near the connector
such as an existing screw with nut in the vehicle’s frame
or drill a 3/32” hole and secure white wire using eyelet
and screw provided.
6.Adhere the black converter box to the frame of the
car using the double-sided tape provided. Secure any
loose parts of the T-connector with the cable ties
provided.
7. Route the 4-flat wire to the center of the vehicle and
out the trunk when in use. When not in use roll up and
store in the battery compartment.
WARNING!
Verify miscellaneous items that may be hidden behind
or under any surface before drilling to avoid damage
and/or personal injury.
02/19/09
56044
CADILLAC CTS