Installation Guide

PA G E 11
Feed two 10 gauge wires, one white and black, from the mounted brake control to
the battery area. Using a ring terminal, connect the black wire to the ‘AUX’ side of
the 30 amp circuit breaker. Leave the white wire to be connected later.
Using a 10/12 gauge butt connector, attach the black wire from the ‘AUX’ side of
the 30 amp circuit breaker to the brake control's black wire. Again using a 10/12
gauge butt connector, attach the white wire from the battery area to the brake
control's white wire. Run a 10 gauge blue wire from the tow vehicle's trailer plug
"brake" terminal to the brake control. Using a 10/12 butt connector, connect this
wire to the brake control's blue wire
WIRING DIAGRAM