Installation Guide

51322-INS-RB
•
07/02/2020
•
ECN7201
•
PAGE 1
INSTALLATION MANUAL
Tools Required
Socket, 7mm, 10mm Ratchet
Socket extension Panel trim
removal tool
Wiring Location(s)
BH1 and BH2
Product Photo
WARNING
Do not exceed product rating or tow vehicle lamp load rating, whichever is lower.
Maintenance
Periodic inspection of all wires and
connections should be performed
to ensure there is no visible damage
or loose connections.
NOTICE
Before you begin installation, read all instructions thoroughly.
Proper tools will improve the quality of installation and reduce the time required.
All steps must be followed to ensure the product will function properly. Once installed,
test for proper function by using a test light or connecting a properly wired trailer.
Level of Difficulty
Easy
Installation difficulty levels are based on time
and effort involved and may vary depending on
the installer level of expertise, condition of the
vehicle and proper tools and equipment.
Wiring Location Guide*
BH1 Under dash, left of steering column, near emergency brake pedal
BH2 Under dash, near center console
BH3 Under dash, in junction box left of steering column
BH4 Behind storage pocket, above ashtray
BH5 Under dash, behind center access panel on the passenger side
BH6 Under dash, near brake pedal
BH7 Behind storage pocket in center of dash
BH8 Under dash, to the right of emergency brake pedal
Gas
Brake
E-brake
BH1BH8 BH6 BH5
BH3
BH4
BH2
BH7