Installation Guide

Gas

Brake

E-brake

BH7

INSTALLATION INSTRUCTIONS

BRAKE CONTROL HARNESS

51436 & 51437 APPLICATIONS

Scan for helpful

installation tips

NOTICE

All steps must be followed to ensure the CURT brake control

harness will function properly. Once installed, test for proper

function by following the brake control unit instruction manual.

Make Model

Ford F-150

Ford Flex

Lincoln MKT (w/ factory tow package)

BH7 - Behind storage pocket in center of dash

Representative vehicle shown below

LOCATION GUIDE

PAGE 1 • RA • NEED ASSISTANCE? • 1.800.798.0813 • CURTMFG.COM

PAGE 1
Scan for helpful installation tips INSTALLATION INSTRUCTIONS 51436 & 51437 APPLICATIONS Make Model Ford F-150 Ford Flex Lincoln MKT (w/ factory tow package) BRAKE CONTROL HARNESS NOTICE All steps must be followed to ensure the CURT brake control harness will function properly. Once installed, test for proper function by following the brake control unit instruction manual.
PAGE 2
INSTALLATION / SAFETY INSTRUCTIONS Step 1 Open the driver-side door and locate the vehicle brake control harness connector under the dash, above the brake pedal. It will be taped to another harness and the connector will be similar to that on the CURT brake control harness (A). On some vehicles the harness may be located in a different location. If it is not located under the dash, skip to step 5. Step 2 Remove tape and protective cover from connector. Take care not to damage the locking tabs.