Owners manual

Gas

Brake

E-brake

BH1

INSTALLATION INSTRUCTIONS

BRAKE CONTROL HARNESS

51442 & 51443 APPLICATIONS

Scan for helpful

installation tips

NOTICE

Make Model

Kia Borrego

BH1 - Under dash, left of steering column, near emergency brake pedal

Representative vehicle shown below

LOCATION GUIDE

All steps must be followed to ensure the CURT brake control

harness will function properly. Once installed, test for proper

function by following the brake control unit instruction manual.

If the vehicle does not supply power to the brake control

harness, a universal brake control wiring kit (#51500) will need

to be installed. Route all wires as directed in the brake control

wiring kit installation instructions.

PAGE 1 • RA • NEED ASSISTANCE? • 1.800.798.0813 • CURTMFG.COM

PAGE 1
Scan for helpful installation tips INSTALLATION INSTRUCTIONS 51442 & 51443 APPLICATIONS Make Model Kia Borrego BRAKE CONTROL HARNESS NOTICE All steps must be followed to ensure the CURT brake control harness will function properly. Once installed, test for proper function by following the brake control unit instruction manual. If the vehicle does not supply power to the brake control harness, a universal brake control wiring kit (#51500) will need to be installed.
PAGE 2
INSTALLATION / SAFETY INSTRUCTIONS Step 1 Locate the 4-pin, vehicle brake control harness connector under the dash, to the left of the steering column. It will be taped to another harness near the emergency brake pedal. The connector will be similar to that on the CURT brake control harness. Step 2 Insert the connector on the CURT brake control harness into the vehicle connector. Make sure the connector is fully inserted with locking tabs in place.