Owners manual

Gas

Brake

E-brake

BH4

INSTALLATION INSTRUCTIONS

BRAKE CONTROL HARNESS

51456 APPLICATIONS

Scan for helpful

installation tips

NOTE

All steps must be followed to ensure the CURT brake control

harness will function properly. Once installed, test for proper

function by following the brake control unit instruction manual.

Make Model

Toyota Tundra

BH4 - To the right of steering column, behind three button panel

Representative vehicle shown below

BRAKE CONTROL HARNESS

LOCATION GUIDE

PAGE 1 • 51456-INS-RA • NEED ASSISTANCE? • 1.800.798.0813 • CURTMFG.COM

PAGE 1
Scan for helpful installation tips INSTALLATION INSTRUCTIONS 51456 APPLICATIONS Make Model Toyota Tundra NOTE All steps must be followed to ensure the CURT brake control harness will function properly. Once installed, test for proper function by following the brake control unit instruction manual.
PAGE 2
INSTALLATION Step 1 Remove the panel below the three button panel. Start at the top left corner near the steering wheel, pulling outward, releasing the tabs that are holding the panel in place one at a time (A,B). Step 2 Repeat step two for the three button panel (C). Step 3 Locate the white, vehicle brake control harness connector behind the three button panel (D). The connector will be similar to that on the CURT brake control harness.