Installation Guide

A B C
D E
Step 1
Locate vehicle battery on the driver side under the
hood and disconnect the negative battery terminal.
Step 2
Open the vehicle tailgate. Remove storage area cover,
rubber mat and spare tire cover (A).
Step 3
Remove the D-rings on the driver and passenger sides.
Remove the rear scuff panel (B).
Step 4
Carefully pull back the driver side interior trim panel; a clip
removal tool may be required. Separate the trim panel in the
rear of the vehicle and work your way up and forward to locate
the vehicle taillight wiring harness connectors. The connector
will be similar to that on the custom connector (C).
Step 5
Insert the custom wiring harness end into the vehicle harness
connector. Make sure the connectors are fully inserted with
locking tabs in place (D).
Step 6
Route the remaining part of the custom connector behind
the trim panel toward the rear of the vehicle.
Step 7
Locate a flat spot inside the vehicle, near the taillight. Adhere
the black converter box using the provided double-sided tape (E).
Step 8
When in use, route the 4-flat to the center of the vehicle. When
not in use, roll up and store in a convenient, out of the way
location. Secure any loose wires with the provided cable ties.
Step 9
Reinstall all items removed during install and reconnect
negative battery terminal. Install the provided 4-flat dust cover
to help prevent corrosion.
INSTALLATION
/
SAFETY INSTRUCTIONS
55106-INS-RC • PAGE 2