Installation Guide

If copying/pasting, eye-drop this text to

ensure a uniform look for all installation

paragraphs.

1. Locate the vehicles factory tow harness it

will be located under the vehicle, behind

the rear bumper on the passenger side

location S7.

2. Remove the protective cap and insert the

4-pin connector into the vehicles factory

tow harness making sure the locking tab is

in place.

3. Route the 4-Flat wire along the backside

of the bumper to the center of the vehicle

making sure to avoid areas that may pinch

or cut the wire. Secure any loose wire with

the cable ties provided.

WARNING!

Verify miscellaneous items that may be

hidden behind or under any surface before

drilling to avoid damage and/or personal

injury.

03/04/09

55244

NISSAN XTERRA

PAGE 1
55244 NISSAN XTERRA 03/04/09 1. Locate the vehicles factory tow harness it will be located under the vehicle, behind the rear bumper on the passenger side location S7. 2. Remove the protective cap and insert the 4-pin connector into the vehicles factory tow harness making sure the locking tab is in place. 3. Route the 4-Flat wire along the backside of the bumper to the center of the vehicle making sure to avoid areas that may pinch or cut the wire. Secure any loose wire with the cable ties provided.