Installation Guide

If copying/pasting, eye-drop this text to
ensure a uniform look for all installation
paragraphs.
1. Locate the vehicles taillight wiring
harness. It will be located behind the
bumper on the drivers side frame rail. The
harness will have connectors similar to
those on the T-connector harness. Separate
the vehicles connectors being sure not to
damage the locking tabs.
2. Insert the T-connector end in-between
the separated connectors. Make sure the
connectors are fully inserted with locking
tabs in place.
3. Locate a suitable grounding point near
the connector such as an existing screw
with nut in the vehicle’s frame or drill a
3/32” hole and secure white wire using
eyelet and screw provided.
4. Route the 4-flat to the center of the
vehicle and secure in a convenient out of
the way location. Secure any loose wires
with the cable ties provided.
WARNING!
Verify miscellaneous items that may be
hidden behind or under any surface before
drilling to avoid damage and/or personal
injury.
5/14/09
55313
FORD F-SERIES
FORD BRONCO