Installation Guide

INSTALLATION INSTRUCTIONS

CUSTOM WIRING HARNESS

WIRING LOCATION GUIDEAPPLICATIONS

NOTICE

WARNING

TOOLS NEEDED

Check vehicle owner's manual or contact

the vehicle manufacturer for more information.

None

Exceeding the product rating can cause loss of warranty,

overheating and potential fire. Do not exceed product rating

or tow vehicle lamp load rating, whichever is lower.

Make Model

Ford F-150

Ford F-250

Ford F-350

Ford F-250 heavy duty

Ford F-350 heavy duty

WARNING: DO NOT EXCEED PRODUCT RATING OR TOW VEHICLE LAMP LOAD RATING, WHICHEVER IS LOWER

PICKUP TRUCKS

(

)

Representative vehicle shown below

T3 - Behind driver side rear bumper

All steps must be followed to ensure the wiring harness

will function properly. Once installed, test for proper function

by using a test light or connecting a properly wired trailer.

PAGE 1 • 55316-INS-RA

PAGE 1
INSTALLATION INSTRUCTIONS WARNING: DO NOT EXCEED PRODUCT RATING OR TOW VEHICLE LAMP LOAD RATING, WHICHEVER IS LOWER APPLICATIONS WIRING LOCATION GUIDE PICKUP TRUCKS (T) Make Model Ford F-150 Representative vehicle shown below Ford F-250 T3 - Behind driver side rear bumper Ford F-350 Ford F-250 heavy duty Ford F-350 heavy duty CUSTOM WIRING HARNESS T3 NOTICE All steps must be followed to ensure the wiring harness will function properly.
PAGE 2
INSTALLATION / SAFETY INSTRUCTIONS Step 1 Locate the vehicle taillight wiring harness connectors (A). The connectors will be similar to those on the custom wiring harness. Separate the connectors from the taillight housing taking care not to damage the locking tabs. Note: Lowering of the vehicle spare tire may ease the installation. Step 2 Insert the custom wiring harness end with yellow wire between the separated connectors. Make sure the connectors are fully inserted with locking tabs in place (B).