Installation Guide

INSTALLATION INSTRUCTIONS

CUSTOM WIRING HARNESS

WIRING LOCATION GUIDEAPPLICATIONS

NOTICE

WARNING

TOOLS NEEDED

Check vehicle owner's manual or contact

the vehicle manufacturer for more information.

Phillips screwdriver

Exceeding the product rating can cause loss of warranty,

overheating and potential fire. Do not exceed product rating

or tow vehicle lamp load rating, whichever is lower.

Make Model

Chrysler Town & Country

Dodge Caravan

Dodge Dakota

Dodge Grand Caravan

Mitsubishi Raider

Plymouth Grand Voyager

Plymouth Voyager

WARNING: DO NOT EXCEED PRODUCT RATING OR TOW VEHICLE LAMP LOAD RATING, WHICHEVER IS LOWER

SUVS, MINI & FULL-SIZED VANS

(

)

Representative vehicle shown below

S1 - Behind driver side taillight housing

S2 - Behind passenger side taillight housing

S1 S2

PICKUP TRUCKS

(

)

Representative vehicle shown below

T1 - Behind driver side taillight housing

T2 - Behind passenger side taillight housing

T2T1

All steps must be followed to ensure the wiring harness

will function properly. Once installed, test for proper function

by using a test light or connecting a properly wired trailer.

PAGE 1 • 55323-INS-RA

PAGE 1
INSTALLATION INSTRUCTIONS WARNING: DO NOT EXCEED PRODUCT RATING OR TOW VEHICLE LAMP LOAD RATING, WHICHEVER IS LOWER APPLICATIONS WIRING LOCATION GUIDE PICKUP TRUCKS (T) Make Model Chrysler Town & Country Representative vehicle shown below Dodge Caravan T1 - Behind driver side taillight housing Dodge Dakota T2 - Behind passenger side taillight housing Dodge Grand Caravan Mitsubishi Raider Plymouth Grand Voyager Plymouth Voyager T1 T2 CUSTOM WIRING HARNESS SUVS, MINI & FULL-SIZED VANS
PAGE 2
INSTALLATION / SAFETY INSTRUCTIONS All Vans Dodge Dakota Step 1 Remove the driver side taillight to locate the vehicle taillight wiring harness connectors. The connectors will be similar to those on the custom wiring harness. Separate the connectors from the taillight housing taking care not to damage the locking tabs (A). Repeat this step on the passenger side. Step 1 Remove the two Phillips screws securing the driver side taillight assembly. Locate the vehicle taillight wiring harness connectors.