Installation Guide

INSTALLATION INSTRUCTIONS

CUSTOM WIRING HARNESS

WIRING LOCATION GUIDEAPPLICATIONS

NOTICE

WARNING

TOOLS NEEDED

Check vehicle owner's manual or contact

the vehicle manufacturer for more information.

Panel trim removal tool

Exceeding the product rating can cause loss of warranty,

overheating and potential fire. Do not exceed product rating

or tow vehicle lamp load rating, whichever is lower.

WARNING: DO NOT EXCEED PRODUCT RATING OR TOW VEHICLE LAMP LOAD RATING, WHICHEVER IS LOWER

PASSENGER CARS

(

)

Representative vehicle shown below

P3 - Behind driver side taillight housing, inside of trunk

P4 - Behind passenger side taillight housing, inside of trunk

P3 P4

All steps must be followed to ensure the wiring harness

will function properly. Once installed, test for proper function

by using a test light or connecting a properly wired trailer.

Make Model

Ford Crown Victoria

Ford Mustang (excl. Cobra SVT 99 - 04)

Mercury Grand Marquis

PAGE 1 • 55326-INS-RA

PAGE 1
INSTALLATION INSTRUCTIONS WARNING: DO NOT EXCEED PRODUCT RATING OR TOW VEHICLE LAMP LOAD RATING, WHICHEVER IS LOWER APPLICATIONS WIRING LOCATION GUIDE PASSENGER CARS (P) Make Model Ford Crown Victoria Representative vehicle shown below Ford Mustang (excl.
PAGE 2
INSTALLATION / SAFETY INSTRUCTIONS Step 1 Open the vehicle trunk. Remove the scuff panel by pulling out on the bottom and then up. Take care not to damage the alignment tabs on the back (A). Step 2 Remove the plastic wing nuts securing the felt trunk liner (B). Step 3 Pull back on the felt liner to locate the vehicle taillight wiring harness connectors. The connectors will be similar to those on the custom wiring harness.