Installation Guide

If copying/pasting, eye-drop this text to
ensure a uniform look for all installation
paragraphs.
1. Open the rear doors and remove the rear
rear scuff panel. Partially remove the rear
interior trim panels. Behind the trim
panels locate the access holes directly
behind the taillights. In the access hole
locate the vehicles taillight wiring harness.
The harness will have connectors that are
similar to those on the T-connector.
2. Starting on the drivers side separate the
vehicles connectors being sure not to
damage the locking tabs. Insert the
T-connector end with the yellow wire
in-between the separated connectors.
Make sure the connectors are fully inserted
with locking tabs in place.
3. Route the T-connector end with the
green wire to the passenger side under the
removed scuff panel. Repeat step 2 on the
passenger side.
4.Route the 4-flat wire to the center of the
vehicle and out of the rear doors when in
use. When not in use roll up and store in an
out of the way location in the rear cargo
area.
WARNING!
Verify miscellaneous items that may be
hidden behind or under any surface before
drilling to avoid damage and/or personal
injury.
4/9/09
55328
DODGE B-SERIES VAN