Installation Guide

A B
Step 1
Locate the vehicle taillight wiring harness connectors. The
connectors will be similar to those on the custom wiring
harness. Separate the connectors from the taillight housing
taking care not to damage the locking tabs (A).
Step 2
Insert the custom wiring harness end with yellow wire between
the separated connectors. Make sure the connectors are fully
inserted with locking tabs in place (B).
Step 3
Route the custom wiring harness end with the green wire to
the passenger side behind the removed scuff panels. Repeat
steps 1-2 on the passenger side using the harness end with
the green wire.
Step 4
When in use, route the 4-flat to the center of the vehicle and out
of the trunk. When not in use, roll up and store in a convenient,
out of the way location inside the trunk. Secure any loose wires
with the provided cable ties.
WARNING: Check for miscellaneous items that may be
hidden behind or under any surface before drilling to avoid
damage and / or personal injury.
Step 5
Reinstall all items removed during install. Install the
provided 4-flat dust cover to help prevent corrosion.
INSTALLATION
/
SAFETY INSTRUCTIONS
55329-INS-RA • PAGE 2