Installation Guide

A B C
D E F
A B C
D E F
INSTALLATION
/
SAFETY INSTRUCTIONS
Step 1
Locate vehicle battery on the driver side under the
hood and disconnect the negative battery terminal.
Step 2
Locate the vehicle taillight wiring connector. The connector will
be similar to that of the custom connector and can be found at
the following locations on each specific vehicle:
Passenger Cars (A)
Open the vehicle trunk and remove the plastic screw securing
the trunk liner on the passenger side. Pull back on the felt liner
to locate the vehicle taillight wiring connector. The connector
will be similar to that of the custom wiring connector.
96 - 99 Isuzu Oasis & 95 - 98 Honda Odyssey (B)
Remove the rear access panel located inside the van,
behind the driver side taillight to locate the vehicle wiring
connector. The connector will be similar to that of the
custom wiring connector.
99 - 04 Honda Odyssey (C)
Open the vehicle trunk and remove the driver side cargo
bracket screw. Pull back the trim panel to locate the vehicle
wiring connector. The connector will be similar to that of the
custom wiring connector.
97 - 01 Honda CR-V (D)
Remove the three screws securing the rear driver side speaker
and cover. Remove the speaker and cover to locate the vehicle
wiring connector. The connector will be similar to that of the
custom wiring connector and will be secured to the speaker wires.
02 - 06 Honda CR-V (E)
Open the vehicle trunk and remove the cargo door on the floor.
Remove the storage container from the vehicle floor and set
aside. Remove the rear threshold and driver side cargo bracket
screw. Remove the cargo screw on the driver side trim panel.
Remove the cargo bracket by unscrewing the bolt from the vehicle
floor. Carefully pry the trim panel away from the vehicle to reveal
the wiring connector taped to wires near the vehicle floor. The
connector will be similar to that of the custom wiring connector.
Acura MDX (F)
Open the vehicle trunk and remove the cargo door on the floor.
Remove the head rests from the storage location. Locate and
remove two clips inside the storage area on threshold. Carefully
pry the threshold to remove it. The vehicle wiring connector will
be located inside the cargo area, on the driver side, attached to
the threshold plate. The connector will be similar to that of the
custom wiring connector. Remove connector from protective cap.
Instructions continued on the page 3
55336-INS-RB • PAGE 2