Installation Guide

ManualsBrandsCURT ManualsOtherCustom Vehicle-Trailer Wiring Harness, 4-Way Flat Output, Select Jeep Grand Cherokee, Quick Electrical Wire T-Connector

A B C

Step 1

Open the vehicle tailgate. Remove the access panel on the

driver side (A). Remove the rear scuff panel and cargo net

brackets on the driver and passenger sides (B). Carefully pull

out the rear trim panels on both sides of the tailgate.

Step 2

Starting on the driver side, inside the access panel locate the

vehicle taillight wiring harness connectors. The connectors will

be similar to those on the custom wiring harness. Separate the

connectors from the taillight housing taking care not to damage

the locking tabs (C).

Step 3

Insert the custom wiring harness end with yellow wire between

the separated connectors. Make sure the connectors are fully

inserted with locking tabs in place.

Step 4

Locate a suitable grounding point near the connector such as

an existing screw with nut in the vehicle frame or drill a 3/32"

pilot hole for the provided screw. The area should be free of

rust, dirt and paint. Secure the white ground wire using the ring

terminal and provided screw.

WARNING: Check for miscellaneous items that may be

hidden behind or under any surface before drilling to avoid

damage and / or personal injury.

Step 5

Route the custom wiring harness end with the green wire

along the backside of the rear trim panel out and under the

scuff panel to the passenger side behind the trim panel.

Repeat steps 2-3 on the passenger side using the harness

end with the green wire (D).

Step 6

Locate a flat spot inside the vehicle, near the taillight. Adhere

the black converter box using the provided double-sided tape.

Step 7

Route the black power wire from the vehicle battery

as shown on the included CME-PCL-INS sheet.

Step 8

When in use, route the 4-flat to the center of the vehicle and out

of the trunk. When not in use, roll up and store in a convenient,

out of the way location inside the trunk. Secure any loose wires

with the provided cable ties.

Step 9

Reinstall all items removed during install. Install the

provided 4-flat dust cover to help prevent corrosion.

INSTALLATION

SAFETY INSTRUCTIONS

55349-INS-RB • PAGE 2