Installation Guide

If copying/pasting, eye-drop this text to
ensure a uniform look for all installation
paragraphs.
1. Open the taillgate and on both the
passenger and drivers side’s remove the
plastic trim panels.
2. On the driver side behind the trim panel
locate the vehicles taillight wiring harness.
The harness will have connectors similar to
those on the T-connector harness. Separate
the connectors being sure not to damage
the locking tabs. Insert the T-connector end
with the yellow wire in-between the
separated connectors. Make sure the
connectors are fully inserted with locking
tabs in place.
3. Locate a suitable grounding point near
the connector such as an existing screw
with nut in the vehicle’s frame or drill a
3/32” hole and secure white wire using
eyelet and screw provided.
4. Route the T-connector end with the
green wire underneath the rubber rear
hatch seal that runs along the threshold, to
the passengers side of the vehicle.
Repeat step 2 on the passenger side using
the green wire.
5. Route the 4-flat wire to the center of the
vehicle and out the hatch when in use.
When not in use roll up and store in an out
of the way location on the drivers side of
the rear cargo area.
WARNING!
Verify miscellaneous items that may be
hidden behind or under any surface before
drilling to avoid damage and/or personal
injury.
8/20/09
55352
OLDSMOBILE CUSTOM CRUISER WAGON
BUICK ROADMASTER ESTATE WAGON
CHEVROLET CAPRICE ESTATE WAGON