Installation Guide

If copying/pasting, eye-drop this text to
ensure a uniform look for all installation
paragraphs.
1. Locate the vehicle’s factory tow harness
location (T4). The harness will have
connectors similar to the one on the
T-connector harness. Remove the protective
cap being sure not to damage the locking
tabs. Insert the harness connector into the
vehicles tow harness connector. Make sure
the connectors are fully inserted with
locking tabs in place.
2. Route the 4-flat to the center of the
vehicle and secure in a convenient out of
the way location. Secure any loose wires
with the cable ties provided.
3. Connect the ring terminal to the vehicle’s
positive battery terminal. On the driver side
of the engine compartment locate the
vehicle’s power wire connector. The
connector will have connection points
matching the power wire connector. Insert
the connector making sure the connectors
are fully inserted with locking tabs in place.
Insert the 10 AMP fuse into the fuse holder.
Secure any loose wires with the cable ties
provided. Make sure to avoid any areas that
may cut or pinch the wires.
7/13/10
55367
TOYOTA TUNDRA