Installation Guide

INSTALLATION INSTRUCTIONS

CUSTOM WIRING

CONNECTOR

WIRING LOCATION GUIDEAPPLICATIONS

NOTICE

WARNING

TOOLS NEEDED

Signal Circuits - 3.0 amps per side

Tail / Running Circuits - 6.0 amps total

Check vehicle owner's manual or contact

the vehicle manufacturer for more information.

None

Exceeding the product rating can cause loss of warranty,

overheating and potential fire. Do not exceed product rating

or tow vehicle lamp load rating, whichever is lower.

Make Model

Chevrolet Tracker

Suzuki Grand Vitara

Suzuki Vitara

Suzuki X L- 7

WARNING: DO NOT EXCEED PRODUCT RATING OR TOW VEHICLE LAMP LOAD RATING, WHICHEVER IS LOWER

SUVS, MINI & FULL-SIZED VANS

(

)

Representative vehicle shown below

S1 - Behind driver side taillight housing

S2 - Behind passenger side taillight housing

S3 - Behind driver side rear access panel

All steps must be followed to ensure the wiring connector will

function properly. Once installed, test for proper function by

using a test light or connecting a properly wired trailer.

PAGE 1 • 55372-INS-RA

PAGE 1
INSTALLATION INSTRUCTIONS WARNING: DO NOT EXCEED PRODUCT RATING OR TOW VEHICLE LAMP LOAD RATING, WHICHEVER IS LOWER APPLICATIONS WIRING LOCATION GUIDE SUVS, MINI & FULL-SIZED VANS (S) Make Model Chevrolet Tracker Representative vehicle shown below Suzuki Grand Vitara S1 - Behind driver side taillight housing Suzuki Vitara S2 - Behind passenger side taillight housing Suzuki XL-7 S3 - Behind driver side rear access panel CUSTOM WIRING CONNECTOR S1 S3 S2 NOTICE All steps must be followed t
PAGE 2
INSTALLATION / SAFETY INSTRUCTIONS Suzuki Vitara / Grand Vitara / Chevrolet Tracker Suzuki XL-7 Step 1 Inside of the driver side tire jack compartment, locate the vehicle taillight wiring harness connector (A). Step 1 Open the vehicle tailgate. Remove the four screws securing the storage compartment to the floor. Remove the storage compartment by lifting the back first (C). Step 2 Locate the 6-pin connector taped to the vehicle wiring harness (B).