Safety Information

For vehicles without a Factory 7-way:
1. Locate the tow vehicle's trailer harness
connector. This harness is located under
the vehicle, behind the bumper, on the
drivers side of the vehicle.(T3)
2. Remove the protective cap from housing
and save. Check to see that the mating
surface of the housing is free of dirt and
clean if necessary.
3. Insert the T-connector housing into the
vehicles housing. Be sure that the
T-connector is fully inserted with locking
tabs in place.
4. Place protective cap on the remaining
plug end.
For vehicles with a Factory 7-way:
1. Locate the factory 7-way attached to the
hitch on the drivers side.(T4)
2. Separate the factory socket and the 7
way.
3. Insert the T-connector between the
factory housing and the 7-way housing.
Be sure that the T-connector is fully
inserted with locking tabs in place.
WARNING!
Verify miscellaneous items that may be
hidden behind or under any surface before
drilling to avoid damage to vehicle and/or
personal injury.
2/25/08
55384
BUICK ENCLAVE
BUICK RAINIER
CADILLAC ESCALADE
CHEVY AVALANCHE
CHEVY SILVERADO
CHEVY TAHOE
CHEVY SUBURBAN
GMC ENVOY
CHEVY TRAILBLAZER
CHRYSLER ASPEN
DODGE DURANGO
GMC ACADIA
GMC SIERRA
GMC YUKON
HUMMER H2 & H3
INFINITI QX56
ISUZU ASCENDER
NISSAN TITAN
NISSAN PATHFINDER
OLDSMOBILE BRAVADA
SAAB 9-7X
SATURN OUTLOOK