Installation Guide

9/2/2010
55510
CHEVROLET COLORADO
GMC CANYON
ISUZU PICKUP I-SERIES
1. Locate the vehicle's tail light wiring
harness underneath the truck bed near
the drivers side frame rail (A). This
harness will have a connection point with
connectors matching the ends of the
T-Connector harness.
2. Separate the vehicle's connectors
taking care not to break the locking tabs
(B). Check to see that the mating
surfaces of the connectors are free of dirt
and clean if necessary.
3. Insert the T-Connector harness
between the vehicle's connectors (C).
WARNING!
Verify miscellaneous items that may be
hidden behind or under any surface
before drilling to avoid damage to vehicle
and/or personal injury.
4. Locate a suitable grounding point near
the connector such as the vehicle’s frame
or cross member (Do not not drill into
vehicle floor or bed). Clean dirt and
rustproofing from area. Drill a 3/32" pilot
hole and secure white wire with ring
terminal using screw provided.
5. Route the T-Connector harness to the
center of the vehicle. Secure converter
and wires to vehicle cross member or
other mounting points using cable ties
and double-sided tape provided.
INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 1-877-287-8634

Summary of content (2 pages)