Installation Guide

If copying/pasting, eye-drop this text to
ensure a uniform look for all installation
paragraphs.
11/6/08
55522
1. Toyota Matrix ONLY
Open the vehicle's rear tailgate, remove
cargo nets and cargo floor hatch to access
the spare tire area. Unscrew nut holding
spare tire cover in place and remove cover.
Set aside all items removed being careful
not to damage parts. Remove the access
panel doors on both sides to access
vehicle's wiring connectors.
Toyota Echo ONLY
Open trunk and remove threshold panel.
Partially remove the corner felt trunk liner,
on both sides, exposing the vehicle's
taillight wiring harness.
2. On the driver and passenger sides of the
vehicle, locate the vehicle's taillight wiring
harness. The taillight wiring harness will
have a connection point, on both sides,
matching the ends of the T-Connector.
Separate this connector, being careful not
to break the locking tabs. All connector
surfaces should be clean and free of dirt.
3. Toyota Matrix ONLY
Locate the access hole on the driver's side
between the spare tire and the rear
threshold. Route T-Connector end with
yellow wire up through the hole to the
access panel.
4. Insert the T-Connector end, with the
yellow wire, between the vehicle wiring
connectors and lock into place. Be sure that
connectors are fully inserted with locking
tabs in place.
5. Route the T-Connector end with green
wire to the passenger's side. Repeat step
2-4 on passenger’s side with T-Connector
end containing the green wire.
TOYOTA ECHO
TOYOTA MATRIX